英文:The reactor network to talk to you about the glass lined reactor explosion problems and welding joints.
1, the shaft and the bearing cover hole is separated from the joint surface (to prevent the explosion of the inside of the shell to the explosive gas mixture, and the relative surface of each component of the explosion case. The structure of the structure and the parameters of the motor shaft of the bearing cover hole of the explosion-proof junction, in normal working condition should not produce friction. When the cylinder type is separated from the joint surface, the minimum gap between the shaft and the bearing cap hole is not less than k;
2, sealing gasket in the maintenance of the need to open the shell parts, the use of compressible material liner as a seal, the sealing gasket should be used as an auxiliary part of the insulation, and can not be included in the insulation joint surface.
Enamel reaction kettle hydraulic system (hydraulic system's role as the pressure increases by changing the pressure. A complete hydraulic system consists of five parts, namely, power components, the implementation of components, control components, auxiliary components (accessories) and hydraulic oil. Hydraulic system can be divided into two categories: hydraulic transmission system and hydraulic control system. Hydraulic transmission system to transfer power and movement as the main function. Hydraulic control system is to make the output of the hydraulic system to meet the specific performance requirements (especially dynamic performance), usually referred to the hydraulic system mainly refers to the hydraulic transmission system. ) sealing device is office media used to avoid leakage and outside the dust and foreign matter invasion, enamel reactor hydraulic system plays a sealing effect of components, namely seals, enamel reactor in the hydraulic system of seals leakage will actuating hydraulic system volume rate of sharp decline, amounting to less than the required work pressure, invaded the fine dust particles, will motivate or exacerbate enamel reactor hydraulic components side wear of friction, further will lead to leakage, therefore, enamel reactor in the hydraulic system of seals and sealing device is hydraulic facilities is a key part.